How To Use - UFESA SV1200 Manual De Instrucciones

ASSEMBLY
Plug the telescopic rod (2) into the recess on the top of the motor unit (4).
Assemble the wings of hanger with screw, place the hanger (1) onto the telescopic rod (2). When you do
this, make sure that the slight bend in the hanger (1) points forwards.
Attach the nylon balloon:
Pull it over the hanger (1). When you do this, make sure that the side with the hole line points forwards.
Put the neck at the top over the collar section (9) on the hanger (1).
Pull the large elastic cord at the bottom over the mounting flange (7).
The device is disassembled in the reverse order.
CAUTION: Only place the device on a stable, flat, moisture-resistant and heat-resistant surface.
Caution! Hot surface! The motor unit / telescopic rod will become hot during use. You should therefore
not touch it during or shortly after use.
It is essential that you follow the care labels for the textiles to be dried!
Never cover up the ventilation slots and do not insert any objects into them.

HOW TO USE

Set the height you want. To do this, open the screw (8), pull out the telescopic rod (2) and then close the
screw (8) again
If you have not already done so, pull on the nylon balloon (see the "Before Initial Use" chapter, "Assembly"
section).
The nylon balloon should sit immediately below the mounting flange (7) so that it can fully inflate.
Pull the garment which is to be pressed over the nylon balloon and the hanger (1) and do up the buttons
if necessary. Make sure that
– the collar is fitted over the collar section (9) on the hanger (1),
– any button strip is over the hole line on the nylon balloon,
– the arms of the nylon balloon fit properly in the sleeves of the garment and are not twisted or scrunched
up,
– all buttons on the garment (including on the sleeves) are done up.
Insert the mains plug into an easily accessible socket.
Turn the timer (6) clockwise and set it to the length of time you want.
Once the nylon balloon has inflated, straighten out the garment and smooth it down again.
SPRAYING
When the set time elapses, the device switches off automatically. The drying / pressing process can be
interrupted at any time by turning the timer (6) to the starting position.
14