HIKVISION I0R2401 Guia De Inicio Rapido página 12


Make sure the plug is properly connected to the power socket.
White Light Illuminator (If supported)

Possibly hazardous optical radiation emitted from this product.

DO NOT stare at operating light source. May be harmful to the eyes.

Wear appropriate eye protection or DO NOT turn on the white light when you
assemble, install or maintain the camera.
Transportation

Keep the device in original or similar packaging while transporting it.
System Security

The installer and user are responsible for password and security configuration.
Maintenance

If the product does not work properly, please contact your dealer or the nearest
service center.

We shall not assume any responsibility for problems caused by unauthorized
repair or maintenance.

A few device components (e.g., electrolytic capacitor) require regular
replacement. The average lifespan varies, so periodic checking is recommended.
Contact your dealer for details.
Cleaning

Please use a soft and dry cloth when clean inside and outside surfaces of the
product cover. Do not use alkaline detergents.
Using Environment

When any laser equipment is in use, make sure that the device lens is not
exposed to the laser beam, or it may burn out.

DO NOT expose the device to high electromagnetic radiation or dusty
environments.

For indoor-only device, place it in a dry and well-ventilated environment.

DO NOT aim the lens at the sun or any other bright light.

Make sure the running environment meets the requirement of the device. The
operating temperature shall be -30 °C to 60 °C (-22 °F to 140 °F), and the
operating humidity shall be 95% or less (no condensing).

DO NOT place the camera in extremely hot, cold, dusty or damp locations, and
do not expose it to high electromagnetic radiation.
Emergency

If smoke, odor, or noise arises from the device, immediately turn off the power,
unplug the power cable, and contact the service center.
Time Synchronization

Set up device time manually for the first time access if the local time is not
synchronized with that of the network. Visit the device via Web browse/client
software and go to time settings interface.
Reflection

Make sure that no reflective surface is too close to the device lens. The IR light
from the device may reflect back into the lens causing reflection.
9