HIKVISION I0R2401 Guia De Inicio Rapido página 11


Keep new and used batteries away from children.

If the battery compartment does not close securely, stop using the product and
keep it away from children.

If you think batteries might have been swallowed or placed inside any part of
the body, seek immediate medical attention.

CAUTION: Risk of explosion if the battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.

ATTENTION: IL Y A RISQUE D'EXPLOSION SI LA BATTERIE EST REMPLACÉE PAR
UNE BATTERIE DE TYPE INCORRECT. METTRE AU REBUT LES BATTERIES USAGÉES
CONFORMÉMENT AUX INSTRUCTIONS.

Improper replacement of the battery with an incorrect type may defeat a
safeguard (for example, in the case of some lithium battery types).

Do not dispose of the battery into fire or a hot oven, or mechanically crush or
cut the battery, which may result in an explosion.

Do not leave the battery in an extremely high temperature surrounding
environment, which may result in an explosion or the leakage of flammable
liquid or gas.

Do not subject the battery to extremely low air pressure, which may result in an
explosion or the leakage of flammable liquid or gas.

+ identifies the positive terminal(s) of equipment which is used with, or
generates direct current. - identifies the negative terminal(s) of equipment
which is used with, or generates direct current.
Fire Prevention

No naked flame sources, such as lighted candles, should be placed on the
equipment.

The serial port of the equipment is used for debugging only.
Hot Surface Prevention
CAUTION: Hot parts! Burned fingers when handling the parts. Wait
one-half hour after switching off before handling parts. This sticker is
to indicate that the marked item can be hot and should not be
touched without taking care. For device with this sticker, this device is
intended for installation in a restricted access location, access can only
be gained by service persons or by users who have been instructed
about the reasons for the restrictions applied to the location and
about any precautions that shall be taken.
Installation

Install the equipment according to the instructions in this manual.

To prevent injury, this equipment must be securely attached to the floor/wall in
accordance with the installation instructions.

Never place the equipment in an unstable location. The equipment may fall,
causing serious personal injury or death.
Power Supply

The input voltage should conform to IEC60950-1 standard: SELV (Safety Extra
Low Voltage) and the Limited Power Source. Refer to the appropriate
documentation for detailed information.

The power source should meet limited power source or PS2 requirements
according to IEC 60950-1 or IEC 62368-1 standard.

DO NOT connect multiple devices to one power adapter, to avoid over-heating
or fire hazards caused by overload.
8