Kohler STERLING 7614 Serie Guia De Instalacion página 12

Position the Whirlpool (cont.)
NOTE: The bath must be installed using the clips (provided). Ensure the fasteners are galvanized or
plated.
Verify the studs are within 1/8" (3 mm) of the bath at the recommended clip or roofing nail
locations. Shim if necessary.
Refer to the "Roughing-In" section for recommended clip locations.
At the side of the stud, position the bottom lip of the clip under the flange of the bath, as shown.
Slide the clip into place between the center of the stud and the bath.
Use a pliers to bend the tab of the clip over the bath flange.
Repeat these steps for the remaining clips.
Secure the clips to the studs with roofing nails or non-tapered flathead screws. Use caution to avoid
hitting the bath with a hammer.
1070292-2-J 12 Sterling