Cleaning And Care - MAURER ZANTE Manual De Instrucciones

7. Close the valve of the gas cylinder.
8. Disconnect the regulator from the cylinder following the instructions
that came with your regulator.
9. Replace the cylinder.
10. In the absence of any flame, remove the plug or seal cap from the
cylinder valve.
11. Check for the presence and good state of the gasket before connecting
the regulator.
12. Perform leak test using soapy water solution.
•
Always close the valve of the gas cylinder after use or in case of a disturbance.
•
Remove the pressure regulator and the hose attachment if the heater is not to be used for a period of time.
•
Cylinder must be stored outdoors in a well-ventilated area out of the reach of children.
•
Disconnected cylinder must have threaded valve plugs tightly installed and must not be stored in garage or any
other enclosed area.
•
Storage of heater indoors is permissible only if the cylinder is disconnected and removed from the heater.
•
Check the tightness of the gas valve and for damage. If you suspect you have a damaged gas valve, have it
changed by your gas dealer.
•
Never store liquid gas cylinder in a sub-terrain, or at places without adequate air ventilation.
•
Wipe off powder coated surfaces with soft, moist rag and soap water.
Do not clean heater with cleaners that are combustible or corrosive.
•
Remove debris, spider and insect nests from ventilation opening of the
cylinder enclosure, control compartment, burner and circulation air
passageways of the heater with heavy-duty pipe cleaner or
compressed air to keep appliance clean and safe for use. Never clear
ports or other openings with toothpicks or other article that will break
and block the ports.
•
If carbon deposits develop, remove the reflector and flame screen and
clean them with soap water. Do not paint the flame screen, control
panel or reflector.
•
Cover the burner unit with the supplied protective cover when the
heater is not in use. Wait until the heater is cool before covering.
•
In a salt-air environment, such as near an ocean, corrosion occurs
more quickly than normal. Check frequently for corroded areas and
repair them promptly.
REPLACING THE GAS CYLINDER

CLEANING AND CARE

STORAGE
WARNING
3. Changing of cylinder must be
undertaken in a flame-free
atmosphere.
4. Make sure that all taps on the
consuming appliance are in
closed position.
WARNING
3. Do not perform maintenance
after heater has been turned
off until the temperature has
cooled down.
4. Do not expose the pilot,
controllers and parts
underneath the burner to
water. Do not use the heater if
any of these parts are
exposed to water until the
appliance is inspected or
repaired by a qualified service
person.