Roughing-In Assembly; Safety Instructions For Assembly; Limitations Of Use; Routing Bus Lines - Schell eSCHELL 00 500 00 99 Manual Del Sistema

Roughing-in assembly

Safety instructions for assembly

5
5.1 Safety instructions for assembly

5.2 Limitations of use

Observe the following limit values for assembly and operation of the system
components:
Permissible ambient temperature
Maximum humidity

5.3 Routing bus lines

All valid national and international regulations, such as D N D
ICE 60364 or CENELEC HD 384, also apply to the routing of bus lines.
The special factors, which need to be observed when installing the bus lines,
are shown below.
There are no special requirements to be met in terms of contact protection
when installing bus lines, because the bus voltage is in the safety extra-low
voltage (
A shielded twisted pair cable is used as the bus line. The cable shield must not
be connected or earthed at either end.
The installation requires special considerations at any point where the bus line
net or might come into contact
– in the distribution box
– in junction bo es, if both the bus line and the
156
Roughing-in assembly
Danger!
Danger to life from electric current!
Touching live connections may cause serious personal injuries.
> Switch off the power supply while carrying out the assembly.
Secure the power supply against reactivation.
> Power and bus line wires, along with terminals, are to be safely
covered to ensure protection against contact. he e
bus power supply unit and the eSCHELL water management ser-
ver must only be installed in areas with exclusive access for com-
petent installers.
L ) range.
Value
0 °C to 50 °C
Max. 100%, no droplet formation,
no corrosive atmosphere (waste water
vapours, salty air, etc.)
ith the net or . for e ample
line are branched.
LL
,