Instruction For Use; Use With Legs - Mopedia CROSSY FIX Manual De Instrucciones

4. To turn on the display the first time (only for RP926) extract the flap positioned to left
of the screen, then start pedaling and the display will automatically turn on (Fig.3);
5. The display shows the number of cycles and the running time. To reset it simply hold
down the red button below the screen for a few seconds. The display automatically
turns off after a short period of inactivity (only for RP926) (Fig.3);
6. To close the pedal exerciser pull outwards the ring of the snap fastener (figure 4) and
close the legs inwards (only for RP924 and RP926) (Fig.2).

10. INSTRUCTION FOR USE

WARNING!
The pedal exerciser require regular maintenance and must be daily checked
to work in a proper way. We suggest to immediately substitute the worn or
broken parts that may cause damages to the patient. It is recommended that
an expert shows how to use the pedal exerciser and that the patient repeat
the procedure under his/her supervision. For a correct rehabilitation it is
necessary to maintain a correct posture. Before beginning the activity, consult
your doctor/therapist.
• Ensure that the screws are all completely clamped before use;
• Place the product in a stable way and in a flat surface;
• The positioning of the pedal exerciser in relation to the height of the seat must permit the
complete distension of the leg without having to incline the pelvis to the right and to the left;
• Start the activity only when the chest is almost straight;
• To gradually effectuate the rehabilitation, the pedal exerciser is equipped with brake for
the regulation of the effort intensity;
• Do not take the feet off the pedals while the pedal exerciser is in fuction;
• At the end of the use, turn clockwise the handle for the brakes regulation, to increase the
power and avoid that the pedals freely rotate causing possible injuries.
WARNING!
The non-compliance of the previous recommendations may cause injuries or
serious health problems.

10.1 Use with legs

1. Place the pedal exerciser in a flat and non slip surface;
2. Sit down in front of the device at a distance that allows to easily insert the feet on the pedals.
Always place the right foot on the pedal labelled with the letter "R" and the left foot on the
pedal labelled with the letter "L".
3. Adjust the foot straps as necessary;
4. Adjust the brake hardness following the doctor or therapist's recommendations.
Note: To increase the effort intesity turn clockwise the brake handle. To decrease the intensity
turn counterclockwise.
5. Activate the device doing a rotatory movement.
7