Scope Connection Configuration - Agilent Technologies U1602A Guia De Inicio Rapido

Scope Connection Configuration

Connect the scope in either single or dual channels with scope probes as
shown in figure 3.
Table 2 Function descriptions of scope menu
Scope Menu Sub Menu
CH1 / CH2 On/Off
MORE 1/2 page
Coupling
Position
CH1 / CH2 Probe
MORE 2/2 page
Invert
Position to 0
Figure 3 Connection for scope measurement
Description
To turn on or off waveform display for channel 1 and channel 2
To select channel coupling:
DC: To display both AC and DC component of the input waveform
AC: DC offset voltage will be removed from the input waveform, only AC com-
ponent will be shown
GND: Input signal is grounded
To adjust the reference ground position, turn rotary switch clockwise to raise to
positive position and vice versa
To set the position, press rotary switch
Select the probe attenuation 1X, 10X or 100X
To turn on or off waveform invert function
Reset the reference ground position to zero volt
9