Default Settings; Initial Start-Up Before Brewing Coffee - Automatic Fill (Plumbed) - Waring Commercial WCM50P Serie Manual Del Usuario

Cafeteras comerciales de llenado manual/automático
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

1. Check rating marking on coffee brewer nameplate to be sure
electric lines match voltage, phase, and amperage requirements
of coffee brewer. Select the proper cord and cord grip for
electrical rating of the coffee brewer.
2. For U.S., 120V coffee brewers are provided with a
120V/15A grounding plug.

DEFAULT SETTINGS

WCM50P
• Temperature – 200°F
• Water connection: Plumbed into water supply
• Volume: 64 oz.
WCM60PT
• Temperature – 200°F
• Water connection: Plumbed into water supply
• Volume: 64 oz.
WCM70PAP
• Temperature – 200°F
• Volume: 85 oz.
INITIAL START-UP BEFORE BREWING COFFEE –
AUTOMATIC FILL (PLUMBED)
CAUTION: The brewer must be disconnected from the power source
throughout the initial setup, except when specified in the instructions.
1. Make sure the unit is in the OFF position (switch located on the
near of the unit).
2. Connect the water line to the water inlet fitting on the rear of the
unit. Do not plug in the power cord at this time.
NOTE: WCM50P/WCM60PT is factory preset in
AUTOMATIC MODE.
3. Insert an empty brew basket into the brew rails of the brewer.
4. To prime the new unit, place an empty decanter under the
brew basket.
5. Connect the brewer to the power source. Once power has been
supplied to the unit, flip the rocker switch to the ON position
(switch located on the rear of the unit).
10
Tabla de contenido
loading

Este manual también es adecuado para:

Wcm60pt serieWcm70pap serie

Tabla de contenido