LG WM4500HA Serie El Manual Del Propietario página 45

Problem
Oversudsing of detergent
svd
• Do not add more than the manufacturer's recommended amount of detergent.
OVERSUDSING
DETECTION
• To remove suds, turn the washer off then back on, then run the Rinse+Spin cycle.
• If too many suds are detected during spinning, the washer stops to help prevent leaking.
Water level is too low or high compared to the load.
PF
• Unplug the washer and wait for 60 minutes. Reconnect power and try again.
WATER LEVEL
SENSOR ERROR
• If the error code is still displayed, call for service.
Inlet hose, drain hose or drain pump is frozen.
FF
• See Care in Cold Climates.
FROZEN ERROR
The Control Lock function is on to prevent anyone from changing cycles or operating
CL
the washer.
CONTROL LOCK
• Turn off the Control Lock function in the control panel. See Control Lock under Options
FUNCTION
It is time to run the Tub Clean cycle.
tcL
• This is not an error code. It indicates that the Tub Clean cycle is running or needs to be run
TUB CLEAN ALARM
ezDispense Error Messages
Problem
The amount of liquid detergent in the detergent reservoir did not decrease.
E d1
After putting the detergent into the detergent reservoir, it was left for a long time and
ezDispense ERROR 1
the detergent hardened.
• Clean the detergent reservoir thoroughly, fill it with liquid detergent, install it in the
The amount of liquid detergent in the detergent reservoir did not decrease.
E dz
• Call for service.
ezDispense ERROR 2
The amount of fabric softener in the softener reservoir did not decrease.
E d3
After putting the fabric softener into the softener reservoir, it was left for a long time
ezDispense ERROR 3
and the fabric softener hardened.
• Clean the softener reservoir thoroughly, fill it with liquid fabric softener, install it in the
The amount of liquid fabric softener in the softener reservoir did not decrease.
E d4
• Call for service.
ezDispense ERROR 4
The amount of liquid detergent/ fabric softener in the detergent/ softener reservoir did
E ds
not decrease.
ezDispense ERROR 5
• Call for service.
The washer was operated without completely closing the drawer.
O PN
The drawer was opened during the washer operation.
ezDispense OPEN
ERROR
• Push the drawer completely closed. If
and Extra Functions.
to clean the washer drum.
drawer, and run a wash cycle. If
drawer, and run a wash cycle. If
Possible Cause & Solution
Possible Cause & Solution
is displayed continuously, call for service.
E d1
is displayed continuously, call for service.
E d3
is displayed continuously, call for service.
O PN
TROUBLESHOOTING 45