Maintenance Regulations - geberit ECO 203 Manual De Operación

Ocultar thumbs Ver también para ECO 203:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 79
Maintenance

Maintenance regulations

Interval
Regularly (before use, at the
start of the working day)
Every six months
After two years at the most
as per specifications on the
service sticker or when the
red and green LEDs flash
alternately.
Cleaning and lubricating the
Geberit pressing tool
WARNING
Risk of fire from short circuit
▶ Never clean the pressing tool
with water or other liquids.
1
Disconnect the mains plug.
2
Clean the roller drive, roller drive
guide and retaining pin of the
pressing tool.
3
Use a brush to remove dirt.
9007201149220747-1 © 02-2018
968.385.00.0 (00)
Maintenance work
▶ Check the pressing tool and mains cable for externally
visible defects and damage that could affect safety.
▶ Clean and lubricate the pressing tool.
▶ Clean pressing attachments and check for defects,
particularly for cracks in the material.
▶ Lubricate the pressing attachments. → See user manual
for the Geberit pressing attachments in question.
▶ Have an authorised repair shop perform a test for safety-
related defects or damage. However, this metrological
measurement does not replace any country-specific
regulations and legislation that might prescribe further
checks and maintenance work.
▶ Have an authorised repair shop check the press capacity
and the state of wear.
4
5
CAUTION
Harmful substances
▶ Observe the safety notes of
the lubricant used.
Lubricate the roller drive, roller drive
guide and retaining pin with
BRUNOX® Turbo-Spray®.
Wipe away excess lubricant using an
absorbent cloth.
EN
31
Tabla de contenido
loading

Tabla de contenido