Yakima EXO SwingBase Wiring Replacement Manual De Instrucciones página 4

7
ROUTE THE NEW LONG WIRING HARNESS.
8
PLUG THE NEW WIRING
HARNESSES TOGETHER.
10
INSTALL THE PLUGS AT THE FONT AND REAR OF THE EXO SWINGBASE™.
Feed the excess wiring into the holes then press and twist 45˚to seat the plugs.
Instruction #1036134A - page 4 of 8
Pull the long wiring
harness out the
back of the EXO
SwingBase™ and
plug the new short
wiring harness into it
until it fully seats.
•
Route the new long wiring harness
through the swingbase as shown.
•
Then, reach into the tubing and
secure the wiring harness in the
clip as show. Squeeze the clip to
close it around the wiring harness.
9
SECURE THE PLUGS.
•
Use the zip-tie to bind
the plugs together.
•
Then, push the plugs
into the opening at
the back of the EXO
SwingBase™.