In Stallation Method - x-sense XS01-WR Manual Del Usuario

08
Loc ations to Avoid
1. Nea r large metal surfaces and/or bundles of wire.
2. Near fl uorescent lights, amateur radios, electrical equipment, or other devices that may transmit an RF signal, a s
electronic "noise" may cause nuisance alarms.
WARNING!
1. THIS ALARM SHOULD BE INSTALLED BY A COMPETENT PERSON.
2. ALARMS SHOULD NOT BE USED AS A SUBSTITUTE FOR PROPER INSTALLATION, USE AND MAINTENANCE OF FUEL
BURNING APPLIANCES INCLUDING APPROPRIATE VENTILATION AND EXHAUST SYSTEMS.

In stallation Method

1. Use the mounting bracket to mark the screw holes on the ceiling or the wall.
2. Drill holes at the two marks using an appropriately-sized drill bit. Insert the anchor plugs and screw the mounting
bracket using the screws provided.
3. Attach the alarm to the mounting bracket and turn clockwise to lock the alarm.
4. Test the smoke alarm according to the steps in the section "Alarm Test".
NOTE: Bef ore installation, it is recommended to test the interconnected smoke alarms in diff erent rooms where you intend to
install these alarms to ensure that they are within the transmission range.
09