Bosch PLR 30 C Manual Original página 28

28 | English
last measured value is at the bottom of the display, the penultimate measured value is
above it, and so on.
Area measurement
For surface measurements, repeatedly press button (2) until the indicator for surface
measurement appears on the display (5).
Then measure the width and length one after the other as with a length measurement.
The laser beam remains switched on between the two measurements. The distance to be
measured flashes in the indicator for area measurement .
The first measured value is shown at the top of the display.
Once the second measurement has been completed, the area is auto-
29.589 m
matically calculated and displayed. The end result is shown at the
29.589 m
bottom of the display, while the individual measured values are
shown above it.
875.51 m
2
Volume measurement
For volume measurements, repeatedly press button (2) until the indicator for volume
measurement appears on the display (5).
Then measure the width, length and height one after the other as with a length measure-
ment. The laser beam remains switched on between the three measurements. The dis-
tance to be measured flashes in the indicator for volume measurement
Once the third measurement has been completed, the volume is
automatically calculated and displayed. The end result is shown at
29.589 m
the bottom of the display, while the individual measured values are
29.589 m
shown above it.
29.589 m
25905.4 m
3
Continuous measurement (see figure C)
In continuous measurement mode, the measuring tool can be moved relative to the tar-
get, during which the measured value will be updated every half a second. You can, for
example, move the required distance away from a wall while reading off the current dis-
tance at all times.
For continuous measurements, repeatedly press the button (2) until the indicator for
continuous measurement
1 609 92A 4P0 | (18.01.2019)
appears on the display (5).
.
Bosch Power Tools