Installation Of Filter Bag; Cleaning; Storage - Workshop WS0255VA Manual Del Propietário

Installation of Filter Bag

Before installing the Filter Bag on the
Vac, clean the area of the Powerhead
Assembly so that the Retainer Band will
seal the Filter Bag against the Powerhead
Assembly and stop small particles from
bypassing the Filter Bag.
If the Filter Bag is clean and not damaged,
replace it on the Filter Cage. If it cannot be
reused, place a new Filter Bag over the
Filter Cage.
Replace the Retainer Band around the
Filter Bag. Make sure the Retainer Band
is positioned on the Filter Bag, and the
Filter Bag completely covers the Filter
Cage. Also, make sure the edges of the
Filter Bag are completely secured under
the Retainer Band.
NOTE: Clean the Filter Bag in an open
area. Cleaning should be done outdoors
and not in the living quarters.
WARNING:
!
Do not remove the filter cage and
float. The float prevents liquid from
entering the impeller and damaging
the motor. The cage prevents fingers
from touching the moving impeller.
SP7102 WS0255VA WORKSHOP.indb 13
MAINTENANCE
(continued)

Cleaning

To keep your Wet/Dry Vac looking its best,
clean the outside with a cloth dampened
with warm water and mild soap.
To clean the Drum:
1. Dump debris out.
2. Wash Drum thoroughly with warm water
and mild soap.
3. Wipe out with dry cloth.

Storage

Before storing your Vac, the Drum should
be emptied and cleaned. The Power Cord
should be wrapped around the unit and
the Hose should be stored as described
in the Power Cord and Hose Storage
Sections in this manual.
should be kept in the same area as the
Vac so they can be readily available.
The Vac should be stored indoors.
The Power Cord cannot be replaced.
If the Cord is damaged, the Vac should be
destroyed and replaced.
13
Accessories
7/10/19 10:57 AM