Klarstein VALERIA BRILLIANT EDITION Manual Del Usuario página 33

Lamp replacement
• The lamp must be replaced by the manufacturer, costumer service or a similarly
qualified person.
• Always switch off the appliance and unplug the power cord from the wall outlet
before carrying out any work on the appliance.
• When handling lamp, make sure it is completely cool down before any direct
contact to hands.
• Do not touch the lamp with bare hands, but use a cloth or gloves to ensure that the
lamp does not come into contact with sweat, as this may shorten the life of the lamp.
• Protect yourself from danger when replacing the lamp, e.g. by wearing gloves.
To replace the lamp:
1. Open the LED light plate assembly and take away the grease filter (see picture 1).
2. Find the light wire at the back of the wire outlet. Then slightly pull the light
connecting wire out, and dismantle the terminal of the light connecting wire (see
picture 2).
3. Remove 4 screws on the hinge of light plate assembly, take out the light plate
assembly and pull out the light wire. If the light wire cannot be pulled out, it can be
cut directly with scissors.
4. Apply the reverse procedure to install the light back.
Picture 1
Picture 3
Picture 2
Technical data of the lamp
ILCOS D code DSS-22/65-S-505/295
Maximum wattage 22 W
Voltage range DC 12 V
Dimensions 505 × 295 mm
EN
33