PAPILLON TB1200 Manual De Instrucciones página 21

cod. 54112 - mod. TB1200
USE INSTRUCTIONS
Follow these steps to connect the attachment to the
upper shaft
1. Loosen the knob by turning it counter-clockwise.
2. Remove the end cap from the attachment
3. Align the button with the guide recess on the upper
shaft
4. Slide the attachment shaft into the upper shaft until
the attachment shaft clicks into place.
Note: If the button does not release completely in the
positioning hole, the shafts are not locked. Slightly rotate
the attachment shaft until the button is locked into place
5. Tighten the locking knob securely by turning it clockwise
Note: During operation, periodically check the knob and tighten as necessary.
Removing the attachment from the upper shaft
See Figure 2.
Disconnect the upper shaft and attachment shaft for storage.
Follow these steps to remove the attachment from the upper shaft.
1. Release the trigger and allow the trimmer to coast to a stop.
2. Unplug the trimmer.
3. Loosen the locking knob by turning it counterclockwise.
4. Push the button, while pulling out the attachment.
Attaching the grass deflector
How to install the protective shield:
Ø Check if the plug is unplugged from the power
socket and if the cutting blade is idle.
Ø Fully overturn the edge cutter
Ø Place the protective shield to fit together the 2
parts of the shield around the shaft of the trimmer
near the head of the trimmer.
Ø Fit the screws and tighten them with a screwdriver.
Important The protective shield should be placed on the grip side, to protect
the operator.
Switching ON or OFF
a) Switch-ON:
Fit the plug in the power socket
Take up a stable position
Grip the appliance firmly
Do not lay the mowing head on the ground
Press the safety push-button and, at the same time, press the switch-ON push-
button
b) Switch-OFF:
Release the switch-ON push-button
Always unplug at the end of every job
- 21 -