Safety And Operating Instructions - Etherma solamagic S2 Instrucciones De Montaje Y Uso

Safety and operating instructions

Please observe the following instructions:
Carefully read through the instruction manual prior to installation and store the
manual safely.
This heater is meant for outside use by adults. It is not meant to be used for in-
door heating to create a pleasant temperature level.
Children must not play with the heater.
Children younger than 3 years old must be kept away from the heater unless they
are continuously monitored.
Caution – Some parts of this product can become very hot and cause burns.
Special care is required when children and vulnerable persons are present.
• Installation tasks must be properly carried out by a qualified person in
accordance with VDE 0100 installation instructions (if applicable, also inclu-
ding Parts 559 and 701).
• When carrying out any work, always switch the system to a zero-volt state
(disconnect mains plug; circuit-breaker off). Switch on the heater only after all
the cables have been completely connected.
• The domestic installation for the power supply of the heater must be designed
with a switch and secured with a fuse of at least 16A slow (type C16A).
• Do not install directly under sockets, junction boxes, switches or electrical
cabling.
• Electrical sockets may only be located in the positions specified in Appendix 2.
• Do not mount the radiant heater close to curtains or combustible materials in
accordance with VDE 0100, Part 559.
• The device meets the requirements for protection type IP 65, if all connectors
(device plug, plugs for expansion components) are plugged in and it is appro-
ved for outdoor use.
• Never leave the heater unattended.
• The heater must always be switched off via the house installation switch when
not in use.
• Do not cover the heater when it is switched on or still hot; there is a risk of fire.
• The wireless receiver is equipped with an overtemperature protection which
will temporarily limit the heating function in the event of an overtemperature.
• To adjust the radiation direction, switch the heater off and allow to cool.
• Do not look directly at an operating IR halogen lamp for a long period and from
a short distance.
• IR halogen lamps are sensitive to direct skin contact (do not touch with bare
fingers). Grease or other contamination can be removed with an alcohol-so-
aked cloth.
99
05/2018