Operation - Etherma solamagic S2 Instrucciones De Montaje Y Uso

Operation

via wireless remote control
Switching
on/off:
Short-term
heating:
Heating level:
Memory-
function:
Timed
switch off:
Synchronisation: If multiple radiant heaters are controlled using the same hand-
05/2018
Brief pressing of the programmed wireless channel button on
the hand-held transmitter switches the connected radiant hea-
ter on or off (LED A: Operating display).
Double-clicking the programmed wireless channel key swit-
ches the radiant heater on for 15 minutes and then automati-
cally switches it off again.
Extended pressing of the programmed key on the hand-held
transmitter switches the heat output up and down between
three levels (33, 66 and 100%). The LEDs signal the selected
heat levels.
Upon switching back on, a short press of the key recalls the last
heating level.
If a timed switch-off has been programmed, the radiant heater
always switches off automatically after the specified time. The
radiant heater signals as follows after the activating the set
residual run time:
Signal duration 2s (Quick flashing LED B) - 30 min. residual run time
Signal duration 4s (Normal flashing LED B) - 60 min. residual run time
Signal duration 6s (Slow flashing LED B) - 90 min. residual run time
If necessary for radiant heater D2, LED B signals the remai-
ning running time every minute by flashing intervals.
Each flashing interval indicates 15 minutes remaining heating
duration.
held transmitter button, faults in the wireless transmission
path can result in different states. For synchronisation, use
the function „Heating level" to initially set all radiant heaters
in switched-on state. Then switch off all receivers by a briefly
pressing the key. The „Heating level" function can now be used
to simultaneously set again all the actuated receivers.
108