Safety And Operating Instructions - Etherma solamagic S1 Instrucciones De Montaje Y Uso

Safety and operating instructions

Please observe the following instructions:
Carefully read through the instruction manual prior to installation and store the
manual safely.
This heater is meant for outside use by adults. It is not meant to be used for in-
door heating to create a pleasant temperature level.
Children must not play with the heater.
Children younger than 3 years old must be kept away from the heater unless they
are continuously monitored.
Caution - Some parts of this product can become very hot and cause burns.
Special care is required when children and vulnerable persons are present.
• Installation tasks must be properly carried out by a qualified person in ac-
cordance with VDE 0100 installation instructions (if applicable, also including
Parts 559 and 701).
• When carrying out any work, always switch the system to a zero-volt state
(disconnect mains plug; circuit-breaker off). Switch on the heater only after all
the cables have been completely connected.
• The heater must be protected with at least a 16A (slow) fuse.
• Do not install directly under sockets, junction boxes, switches or electrical
cabling.
• Electrical sockets may only be located in the positions specified in Appendix 2.
• Do not mount the radiant heater close to curtains or combustible materials in
accordance with VDE 0100, Part 559.
• The device meets the requirements for protection type IP 44, if all connectors
(device plug, plugs for expansion components) are plugged in and it is appro-
ved for outdoor use.
• Never leave the heater unattended.
• Do not cover the heater when it is switched on or still hot; there is a risk of fire.
• To adjust the radiation direction, switch the heater off and allow to cool.
• Do not look directly at an operating IR halogen lamp for a long period and from
a short distance.
• IR halogen lamps are sensitive to direct skin contact (do not touch with bare
fingers). Grease or other contamination can be removed with an alcohol-so-
aked cloth.
• To maintain the service life of the IR halogen lamp, it must be protected against
vibrations, impacts and contaminants such as acids, ammonia, cement dust,
etc.
109
05/2018