Etherma solamagic S2 Instrucciones De Montaje Y Uso página 102

Step 1: Installing the T-bracket
• Install the radiant heater using 2 T brackets at a separation of 400 mm while
observing the safety distances and safety instructions (see Appendix 2).
• Secure the T-bracket (1) with the silicone plate (2) below it on the fastening
surface with 2 screws each according to the following figure. When wall-
mounted the heater swivels to the horizontal, lower longitudinal hole side.
When mounting on the ceiling/roof, the swivel range must be aligned for opti-
mum heating effect towards the opposing longitudinal hole side (in contrast to
the image below, swivel range 30°).
Step 2: Installing adapter claws on the T-brackets
• Fit adapter claws (6) at the two T-brackets mounted on the fastening surface,
fit safety washer (12) between the T-bracket and adapter claw and screw in M6
socket cap screws (11) from outside into the T-bracket.
05/2018
15
2 1
102
12 6
11
A