First Use - T-Fal NutriCook Guía De Uso

EN
The Smart Timer
button cells that contain lead. These batteries meet
North American standards.
• You can replace the Smart Timer
54 (389) type batteries or have them replaced by a
supplier used to providing this kind of service.
• To remove the batteries form your Smart Timer
the battery cover using a coin. Fig 11.
• Always gently close up the battery cover, never forcing
past its stop. Fig 11.
Recommendations for use
• Never force down the battery cover when closing it.
• If you lose the cover, you can obtain a replacement
from all T-fal Approved Service Centres.
Always position the
NutriCook so that the
selector faces you.
open my NutriCook
Never force the
Nutricook open, make
sure the pressure
indicator is down in the
normal position.
13
®
batteries are manganese alkaline
®
's LR 54 (189) or SR
• Fill the NutriCook to the two-thirds mark (the
maximum mark) with cold water.
• Place the steaming basket in the NutriCook.
• Close the NutriCook.
• Move the pressure selector to PROG 4.
• Set the Smart Timer
• Place the NutriCook on a heat source set to maximum
power.
• When the signal sounds, the Smart Timer
that you need to turn the heat down so there is a
constant, steady release of steam. Fig. 12.
The steam cooking with pressure phase starts.
• Once the first phase is finished, the beep sounds and
the Smart Timer
the heat and move the cooking programme selector
®
(F) to
• Hot steam, and possibly droplets of water, escape from
the steam outlet (A) in a vertical direction.
The soft cooking phase starts (this time is ready
programmed).
• When the soft pressure cooking phase is finished, the
Smart Timer
finished.
• Check that the pressure indicator (D) has dropped back
down.
• Raise the Open/Close handle to the vertical position to
open the lid. Fig.1.
• Remove the Smart Timer
it.
®
, open
®
for 20 minutes.
®
indicates that you need to turn off
. Fig. 8.
®
's beep sounds indicating that cooking is
.
®
, rinse the NutriCook and dry

First use

®
indicates