Thermal Paper Specifications; Replacement Of The Paper Roll; Reprinting Of Results; Setup Mode - TerraTec Bionova MiniBio Manual Del Usuario

Instructions for use

Thermal paper specifications

Recommended paper: JUJO AF50KSE3 or similar (order code
ICTP).
Paper width : 58 mm
Maximum paper thickness: 60 g/m
Maximum diameter size: 23 mm

Replacement of the paper roll

The printer uses thermal paper rolls
NOTE: You can check the correct paper replacement
by pressing , this button will force the advance of
the paper a few centimeters.
2
.
1.To replace the paper roll,
pull the handle of the printer's
door. Open the printer's cover
and remove the spent roll.
2.Place the new paper roll
with the outer side up.
3.Close the printer cover by
pressing on the sides of the
lid.
Bionova

Reprinting of results

The incubator allows reprinting of the last 3 results by
fluorescence readout. For printing the results, press the button
for 3 seconds.

Setup Mode

Bionova MiniBio has a setup mode from which, the equipment
®
time zone and the print language can be set up. To enter Setup
mode, turn on the incubator while holding down the button
The red and green LEDs in the three positions will remain on,
indicating that the device is in this mode. The printer will render
a ticket indicating that it is in Setup Mode.
To change the time zone and the print language, follow the
instructions below. When finished, restart the computer to exit
Setup mode.
NOTE: Remember that it is possible to synchronize
the time with the Bioupdate
Traceability Software.
Modification of time zone
The time zone modification function allows changing the time
zone of the device to suit the time zone of your country.
To make this change, the incubator must be started in Setup
mode (see Setup Mode), then press the button
The current time will be printed to set a reference.
To subtract hours, press the button
necessary. To add hours, press the button
necessary. After 2 seconds, a ticket will be printed informing the
selected time.
To confirm the change hold down the button
seconds. To discard the changes, unplug the incubator from
the power source.
Modification of printing language
This functionality allows changing the language in which the
incubator printer renders the tickets.
To make this change, the device must be started in Setup mode
(see Setup Mode), then press the button
MiniBio Page 11
®
.
software and Bionova
® ®
.
as many times as
as many times as
for 3
.