Safety Instructions - Tripp-Lite B024-DUA8-SL Manual Del Propietário

Safety Instructions

• Read all instructions and save for future reference.
• Follow all warnings and instructions marked on the device.
• Do not place the device on any unstable surface (cart, stand, table, etc.). If the
device falls, serious damage will result.
• Do not use the device near water.
• Do not place the device near or over radiators or heat registers. The device cabinet's
slots and openings allow for adequate ventilation. To ensure reliable operation and
to protect against overheating, these openings must never be blocked or covered.
• The device should never be placed on a soft surface (bed, sofa, rug, etc.), as this
will block its ventilation openings. The device should also not be placed in a built-in
enclosure, unless adequate ventilation is provided.
• Never spill liquid of any kind onto the device.
• Unplug the device from the wall outlet before cleaning. Do not use liquid or aerosol
cleaners. Always use a damp cloth for cleaning.
• The device should operate from the power source type as indicated on the marking
label. If unsure what power type is available, consult your dealer or local power
company.
• Do not allow anything to rest on the power cord or cables. Route power cord and
cables so they cannot be stepped on or tripped over.
• If an extension cord is used with this device, make sure the total ampere ratings of
all products used on this cord does not exceed the extension cord ampere rating.
Make sure the total of all products plugged into the wall outlet does not exceed 15
amperes.
• To help protect your system from sudden transient increases and decreases
in electrical power, plugging your devices into a Tripp Lite surge protector, line
conditioner, or uninterruptible power supply (UPS) is recommended.
• When connecting or disconnecting power to hot-pluggable power supplies, observe
the following guidelines:
o Install the power supply before connecting the power cable to the power supply.
o Unplug the power cable before removing the power supply.
o If the system has multiple sources of power, disconnect power from the system by
unplugging all power cables from the power supplies.
• Never push objects of any kind into or through cabinet slots. They may touch
dangerous voltage points or short out parts resulting in a risk of fire or electrical
shock.
• Do not attempt to service the device. Refer all servicing to qualified service
personnel.
17-10-479-93370A.indb 7
7
11/17/2017 2:28:58 PM