Installing The Cloth Puller Cover; Installing The Handwheel; Installing The Thread Stand - JUKI MS-3580 Serie Manual De Instrucciones

6. Installing the cloth puller cover

7. Installing the handwheel

State that cloth puller cover and handwheel are
installed
1

8. Installing the thread stand

1
2
2
2
1
− 6 −
Install top feed cloth puller cover 2 with two
•
setscrews 1 supplied with the machine as
accessories.
• Tightening torque of the screw is 2.5 to 3 N•m.
Turning the sewing machine by hand, per-
form positioning of the cover so that the
cover does not come in contact with the
sewing machine.
Install handwheel 2 with three setscrews 1 supplied
•
with the machine as accessories.
(It is not necessary when MT03 is installed.)
• Tightening torque of the screw is 2.5 to 3 N•m.
1) Assemble the thread stand as shown
in the fi gure and install it in the hole of
the table.
Tighten nuts 1 to such an extent that
2)
the thread stand does not move.
3) When using power supplied by the
overhead power line, pass the power
supply cord through thread stand 2 .