Tabla de contenido
Idiomas disponibles
Idiomas disponibles
www.evolutionpowertools.com
secure the Brush Skirt and lens into the Sanding Head.
• Carefully pull and ease the Brush Skirt and lens from the
Sanding Head.
• Installation of a new Brush Skirt is basically the reversal of the
removal process.
• During installation of a new Brush Skirt take care to not over
tighten the six (6) self tapping screws. These should be firmly
tightened but be careful not to strip the threads within the
tapped holes.
• Ensure that the special fixing clips are correctly positioned.
• Reinstall the Sanding Pad on the motors drive spindle and
secure in place with the Hex Headed Socket Screw.
Note: Changing the Brush Skirt will expose the interior of the
Sanding Head. The operator should take the opportunity to
examine, clean and remove any debris from within the Sanding
Head, or from the exhaust ports and exhaust tubes fastened or
contained within it.
(6.1) WARNING: Any maintenance must be carried out with
the machine switched off and disconnected from the mains/
battery power supply.
Check that all safety features and guards are operating correctly
on a regular basis. Only use this machine if all guards/safety
features are fully operational.
All motor bearings in this machine are lubricated for life.
No further lubrication is required.
Use a clean, slightly damp cloth to clean the plastic parts of the
machine. Do not use solvents or similar products which could
damage the plastic parts.
WARNING: Do not attempt to clean by inserting pointed
objects through openings in the machines casings etc. The
machines air vents should be cleaned using compressed dry air.
Excessive sparking may indicate the presence of dirt in the
motor or worn out carbon brushes.
(6.2) If this is suspected have the machine serviced and the
brushes replaced by a qualified technician.
ENVIRONMENTAL PROTECTION
(6.4)
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your Local Authority or retailer for recycling advice.
15
EN
Tabla de contenido
