Automatic Refrigerator
TRA390510MD
2. INSTALLATION
2.3 Door Space Requirements
The unit's door must be able to open fully as shown.
W×D≥1180×1100mm
2.4 Levelling the Unit
W
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the door and magnetic seal alignments
will not be covered properly.
Make sure that the foot touches the ground before use.
Look down from the top, clockwise and counterclockwise loosening,
tightening.
2.5 Cleaning Before Use
Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm water using a'Wrung-
out' sponge or cloth. Wash the shelves and salad bin in warm soapy water and dry completely before replac-
ing in the unit. Clean the exterior of the unit with a damp cloth.
If you require more information refer to the Cleaning section.
2.6 Before Using Your Unit
The refrigerator adopts 115~V/60Hz AC power, voltage fluctuations over the range of 97 ~ 132V will cause
malfunction or even damage, so a 750 W automatic voltage regulator must be installed in concert with the
AC power.
Do not damage the power cord under any condition so as to ensure safety use, do not use when the power
cord is damaged or the plug is worn.
Do not put flammable, explosive, volatile and highly corrosive items in the refrigerator to prevent damages to
the product or fire accidents.
Do not place flammable items near the refrigerator to avoid fires.
This product is household refrigerators and shall be only suitable for the storage of foods. According to nation-
al standards, household refrigerators shall not be used for other purposes, such as storage of blood, drugs or
biological products.
Do not place items such as bottled or sealed container of fluid such as bottled beers and beverages in the
freezer to prevent bursts and other losses.
18