Installation; Ubicación; Reversing The Door Swing - Telstar TRA390510MD Manual De Instrucciones

Automatic Refrigerator
TRA390510MD

2. INSTALLATION

2.1 Ubicación
When selecting a position for your unit you should make sure the floor is flat and firm, and the room is well
ventilated. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sun-
light as it may increase the electrical consumption. Extreme cold ambient temperatures may also cause the
unit not to perform properly. This unit is not designedfor use in a garage or outdoor installation. Do not drape
the unit with any covering.
When installing the unit, ensure that 10cm of free space is left at both sides, 10cm at the rear and 30 cm at the
top of the unit. This will allow cold air to circulate around the wine cooler and improve the efficiency of the
cooling process. The door can be opened to the right or the left, depending on what better suits the location.
Please ensure there is adequate space for the door to fully open.

2.2 Reversing the Door Swing

1. Remove the screws of the upper hinged cover
and that top hinged cover on one side.
2. Then, remove the middle hinge, lower hinge and
door. After that, remove the upper, middle and lower
hinges on the other side.
3. Install the lower hinges. Then put on the middle
hinge after the door is put in place. After that, install
the refrigerator door and then put on the upper hinge
and cover.
4. Adjust the height of the adjustable foot of the low-
er hinge. Make sure that the foot touches the ground
before use.
17