Kohler K-6816 Manual Del Usuario página 14

Wall Plate
Escutcheon
Wall Sleeve
Gasket
Support Bar
Center Cap
10. Install the Mirror
Install the Posts
Place the mirror face down on a flat, padded surface.
Insert a post over each stud.
Insert a bearing into each post. Align the holes in the bearing
with the hex slots on the post.
Slide a center cap over each post. Align the holes in the center
cap with the hex slots in the post.
Slide a support bar through each bearing.
Align the posts to the same plane for the proper mirror angle.
Screw a knob and washer onto each support bar.
Mount the Mirror
Place the escutcheon, sleeve, and gasket over the wall bracket.
Orient the holes in the post horizontally, then secure with a
mounting screw.
Place a bearing in the post and replace the center cap on the post.
Slide the support bar into the bearing.
Place the sleeve over the bracket extension.
Screw the bracket onto the support bar.
Place the sleeve over the opposite end of the support bar.
Screw the end cap with a washer onto the support bar.
1020822-2-B
Measure distance.
Post
Stud
Sleeve
Bearing
14
Support Bar
Mirror
Kohler Co.