Assembly - ProFitter KFA400PF2 Manual De Instrucciones De Operación Y Lista De Partes

ProFitter Operating Instructions and Parts Manual
TM
Model KFA400PF2
Product Features
Figure 3 – Model KFA400PF2 Features
Wheels Cord Wraps
Figure 4 – Component Identification

Assembly

TOOLS REQUIRED
• Medium Phillips screwdriver
• 24mm socket or adjustable wrench.
ASSEMBLING WHEEL & HANDLE
1. Slide threaded axle through the rear
section of the wheel support frame.
2. Slide one axle bushing on to each side
of the axle. Slide one wheel on to each
side of the axle. Attach one cap nut on
to each side of the threaded axle and
tighten well.
For Technical Support or Troubleshooting, Call: 1-877-447-4768, 8:30 am - 4:30 pm CST www.ghpgroupinc.com
Hot Air Outlet
Lower Shell
Fuel Gauge
Fuel Cap
Lamp
Thermostat Knob
Room Temp. Display
Operating Switch
Screw (L) Screw (S)
Cap Nuts Bushing Washers
Hardware Kit Part No: HW-KFA1019
3. Place heater on wheel support frame.
Make sure air inlet end (rear) of
heater is over wheels. Align the holes
on fuel tank flange. Insert screws(L)
through handles (front and Rear), fuel
tank flange, and wheel support frame.
Insert screws(S) through rear handle,
fuel tank flange, and washer(S) as
shown in figure 5 and attach nut finger
tight after each screw is inserted.
4. After all screws are inserted, tighten
nuts firmly.
Front Handle
Upper Shell
Fuel Drain Bolt
Power Cord(Piggy back)
Nut
Cap Nuts(S)
Wheel Support Frame
3
Rear Handle
Cord Wrap
Fan Guard
Fuel Tank
Front Handle
Threaded Axle
5. Align the hole on the rear handle
with the mounting hole on the cord
wrap.
6. Insert screws through cord wrap, rear
handle as shown in Figure 5 and
attach nut finger tight after each
screw is inserted.
7. After all screws are inserted, tighten
nuts firmly.
DO NOT operate
CAUTION
heater without
support frame fully assembled to tank.
Rear Handle