Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Disassemble and carefully inspect helmets that have been exposed to excessive heat
ore have taken an impact. Replace ANY part showing wear or damage.
Helmets absorb the energy of a blow by partial destruction of, or damage to, the
helmet. Even though such damage may not be readily apparent, any helmet subjected
to a severe impact should be replaced immediately.
If there is a damage, remove the helmet from service immediately and repair or replace
the damaged part before using the helmet again.
NEVER use a damaged helmet !
Helmet Shell – Replace if any of the following conditions are evident
a)
Any cracks, dents or deep scratches > 1mm
b)
Deformations (from mechanical impacts, exposure to excessive heat, flame etc.)
Visors – Faceshields
a)
Replace if blistered, bubbled, cracked, or charred
b)
Replace if deformations or other heavy damages occur
c)
Replace if lens does not stay in the stowed position and/or cannot be adjusted
Edge Trim
a)
Reattach if separated but intact (ask manufacturer for special heat resistant glue)
b)
Replace if damaged
Reflective Trim
a)
Replace if damaged, nonreflective or missing
Chinstrap – Replace if any of the following conditions are evident
a)
Frayed, missing, or broken parts
b)
Frayed, cut or broken stitching
c)
Worn-out hook and loop parts
d)
Broken, worn-out or missing release buckle
Suspension straps - Replace if any of the following conditions are evident
a)
Cut, or broken stitching
b)
Tears or abrasions on straps
c)
Brittleness
d)
Discoloration
Head band - Replace if any of the following conditions are evident
a)
Brittleness
b)
Cracked or broken
HEROS Titan Pro – Rosenbauer
EN
13
Tabla de contenido
