Initial Installation; Important - Toshiba 24D153DG Serie Manual Del Usuario

Before switching on the TV, put your decoder and media recorder to Standby if they are connected and
ensure the aerial/cable is connected to your TV. To set up the TV, use the buttons on the remote control as
IMPORTANT: Ensure that the aerial/cable is connected and
a Common Interface module is not inserted before switching
on the TV for the first time installation.
1. Connect the mains plug, press and hold the
middle of the menu wheel on the left side of
the TV to switch the TV on. If the TV does not
switch on, press any numbered or
the remote control, then the language selection
menu will be displayed. This screen will appear
the first time that the TV is switched on and each
time the TV is reset.
2. By pressing Up or Down button, highlight the
language you want to set and press OK button.
The following screen will be displayed next:
3. By pressing Left or Right button, select the
country you want to set and press Down button
to highlight the Search Type option. Use Left or
Right to set the desired search type. Available
search types are Digital only, Analogue TV
only and Full.
4. When set, press Down button to highlight
Teletext Language. Use Left or Right button to
select desired language region. Highlight Scan
Encryted Channels and enable/disable this

Initial Installation

detailed on The Remote Control page.
Note: Depending on the Country selection you may be asked
to set and confirm a PIN at this point. The selected PIN cannot
be 0000. You have to enter it if you are asked to enter a PIN
for any menu operation later.
button on
5. The following message will be displayed next on
6. Press OK button on the remote control to continue
7. Select Yes by using Left or Right button and
8. If you select Cable option, a confirmation screen
English - 11 -
option by using Left or Right buttons. Press OK
to continue.
the screen:
Select Store mode if the TV will be placed in a
store to exhibit. This option will configure your
TV's settings for best display quality and the
supported features of the TV will be displayed on
the top of the screen as a info banner. If Store
mode is selected, a confirmation screen will be
displayed. Select YES to proceed. For home use
select Home Mode.
This option will be available in Other Settings
menu and can be turned off/on later.
and the following message will be displayed on
the screen:
press OK button to continue. Afterwards, the
following OSD will be displayed on the screen:
will be displayed. If you want to search for
available networks, select YES to proceed. The
following screen will be displayed: