Before Use; Assembling The Appliance - Klarstein 10031935 Manual Del Usuario

BEFORE USE

Cleaning:
Before using the first time, wipe all parts of the appliance. Clean all trays, damper door
and non-stick sheet with a lightly moistened cloth. Use detergent as needed. Don't put
the main engine into water or other liquids!
After cleaning, the unit must be run for 30 minutes without placing any food for drying
during this period. Any smoke or smells produced during this procedure are normal.
Please ensure sufficient ventilation. After the running in period, rinse the racks in water
and dry all parts. This act is only necessary for the first time, but don't put the main
engine into water or other liquids.
Unplug the dehydrator from the power supply and let it cool down before cleaning. Use
a soft brush to remove food sticking. Dry all parts before storing the dehydrator.
Do not clean the appliance with aggressive chemicals or abrasives in order not to
damage the surface.

ASSEMBLING THE APPLIANCE

Make sure that the dehydrator on a level surface. Stock the drying trays and connect the
plug with a wall socket. The dehydrator is now ready for use.
Usage Method
1. Put the clean food in the trays – Do not overload the trays and never overlap the
food. Close the damper door.
2. Plug dehydrator into wall outlet. There is a beep sound at the beginning when it
starts up. Press the power button, The LED screen will show default time setting
"10:00" and temp setting "70 °C". Motor and fan start first, then heating element
start working 5 seconds later. Set time begins to count down, the signal ":" on LED
screen flashes.
3. Press the "TIMER" button and LED screen shows the time value. According to actual
needs, press UP or DOWN button to change the drying time between "0:30" and
"19:30". Press UP or DOWN button once, the time increment or decrement is 30
minute/press. If press UP or DOWN button for long time, then it automatically
increases or decreases. 3 seconds after finish setting the drying time, system
automatically gets into operating mode in current time setup.
4. Press the "TEMP" button and LED screen shows the temp value. According to actual
needs, press UP or DOWN button to change the drying temp between "35 °C"
and "70 °C". Pres sUP or DOWN button once, the temp increment or decrement
is 5 °C/press. If press UP or DOWNbutton for long time, then it automatically
increases or decreases. 3 seconds after finish setting the drying temp system
EN
17