Putting Out Of Operation; Maintenance And Cleaning; Electric Shock; Monthly Cleaning - Abicor Binzel CAT2 Traducción Del Manual De Instrucciones Original

CAT2

8 Putting out of operation

9 Maintenance and cleaning

9.1 Monthly cleaning

10 Troubleshooting and its solution
Putting out of operation depends on the respective welding torch.
Scheduled maintenance and cleaning is a prerequisite for a long life and a
trouble-free operation. In doing so, observe the following:
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Close off the compressed air supply.
• Pull the mains plug.
DANGER

Electric shock

Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation.
• Replace any damaged, deformed or worn parts.
NOTE
• The maintenance intervals given are approximate values and refer to
single-shift operation.
• Maintenance and cleaning work may only be carried out by qualified
and trained specialists.
• Always wear your personal protective clothing when performing
maintenance and cleaning work.
Remove once a month dirt and welding spatter from CAT2.
NOTE
• Some problems are listed below, with descriptions of possible causes
and solutions. If the measures described below are not successful, please
consult your dealer or the manufacturer.
8 Putting out of operation
EN - 15