Makita BFL201R Manual De Instrucciones página 6

Status of
the LED indicator/beeper
LED indicator Beeper
Lights up in
A series of
red and green
short beeps
alternatively
Blinks in red A series of
quickly. short beeps
Green (blue
when batch is
completed in
tool stand-
alone mode)
Lights up in
A long beep
red.
Lights up in
A long beep
yellow.
Blinks in red
and yellow A long beep
alternatively.
Blinks in red
A series of
and blue
short beeps
alternatively.
Note: These values can be changed on PC. Refer to SRCV02 USER MANUAL for details.
6
Function
This function works when an abnormal
Anti-reset of
drop of the battery voltage occurs for
controller
some reason, and the tool stops.
Failure of motor This function works when motor fails.
This function works when the
Overheat temperature of the controller or motor
goes up very highly, and the tool stops.
This function works when the tool has
Auto-stop reached within the fastening torque
fastening range preset on PC and normal
tightening has been completed. (Note)
Result of torque This function works when the tool has
judgment: NOK reached above the fastening torque
(High) range preset on PC. (Note)
Result of torque This function works when the tool has
judgment: NOK reached below the fastening torque
(Low) range preset on PC. (Note)
Warning against Fastening is imcomplete when switch
insufficient trigger of tool is released before clutch
fastening activation.
Double-hitting This function works when a screw is
detection refastened after fastening.
This function works when a screw is not
Angle judge NOK fastened within the angle range preset
on PC (Note).
This function works when a fastening is
Rundown NOK finished before it reaches the preset
angle range. (Note)
This function works when torque
Torque impossible
monitoring is cannot be carried out.
monitoring
(When using hard joint)
Disconnection
Radio communication not yet
(when using
established
receiver RCV02)
Radio
This function works when there is radio
communication
communication failure.
failure
Status Action to be taken
Replace the battery
with fully charged
one.
Take it to a Makita
Authorized Service
centers.
Remove the battery
cartridge immediately
and cool the tool
down.
__
__
__
__
__
__
__
__
Finish necessary
connection or remove
a battery cartridge to
escape.
Take it to a Makita
Authorized Service
centers.