Miniland thermosense Manual Del Usuario página 33

forehead (C) measuring buttons at the same time until you hear one
or two "beep" sounds.
5.10. TROUBLESHOOTING
PROBLEMS
No response /
Automatic reset
when pull out
insulator
"Lo" on screen
"Hi" on screen
"ErrP" or "ErrH"
on screen.
"ErrE" on screen. Operating temperature is
The measurement
is not accurate or
if there is any
doubt om the
measured result
CHECKLIST
Batteries used up
Batteries in wrong polarity Take out the batteries
Poor battery contact
The measured
temperature is lower than
32.0°C/89.6°F.
Please check the
operation method
The measured
temperature is higher
than 42.9ºC/109.3ºF.
Please check the
operation method
Hardware problem
out of the range
The sensor temperature
has not been stabilised
Please check if the the
infrared sensor (J) is
clean or not
Please check the
measuring way is
corrector not
33
ENGLISH
SOLUTIONS
Change the batteries
for new ones
and reinsert them
correctly
Follow user's
manual for proper
measurement
Follow user's
manual for proper
measurement
Contact the
manufacturer or
distributor.
Use the thermometer
in the range of
operating conditions
Wait about 10
seconds and take a
measurement again
Clean the infrared
sensor (J) with cotton
swab according to
user manual
Ensure you have
read the manual and
know how to use the
thermometer properly