Cord Assembly - Kenmore 721.33189 Manual Del Propietário

STRETCH HOSE
ASSEMBLY
Stopper
k_ Lower
II I_ --_'-_.Hose Holder
I I,Jj
/
J
_ling
Stretch
Hose
Attach the lower hose holder provided in the
accessory bag to the body and then clip hose
into the lower hose holder with the hose stopper
placed just above the lower hose holder.
Lastly, slide hose onto the hose coupling on
the floor nozzle and twist hose.
Make sure hose is firmly connected before
using the vacuum.
CORD ASSEMBLY
Make sure the quick release cord hanger is in
the upright position.
Lock the cord into
place by forcing it
into the locking
notch on the
handle as shown.
This helps keep the
power cord out of
the path of the floor
nozzle.
Notch
Cord
Quick-
Release Cord
Hanger
Cord
Handle
Wrap the power
cord around the
quick release cord
hanger and carry
handle, and clip
the plug onto the
power cord.
OPERATING INSTRUCTIONS
1.
Turn the quick
release cord hanger
to either side and
down to release the
power cord.
0 -_Quick t_.\ Release
_'_ Cord
/////Hanger
2. Unclip the plug from the power cord and pull
the cord off the quick release cord hanger.
Check to be sure the power cord is still locked
into the locking notch. See CORD ASSEMBLY.
3. Check to see if the cleaner has bag
installed. See DUST BAG CHANGING.
4.
Plug the polarized power cord into a 120
Volt electrical outlet.
NOTE: To reduce the risk of electric shock, this
vacuum cleaner has a polarized plug, one
blade is wider than the other. This plug will fit in
a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to
install the proper outlet. Do not change the plug
in any way.
WARNING
Personal Injury and Product Damage
Hazard!
• DO NOT plug in if switch is in ON
position. Personal injury or product
damage could result.
• DO NOT use outlets above counters.
Damage to items in surrounding area
could occur.
-6-