Luminance Brands Kathy Ireland Home PENBROOKE SELECT ECO CF5200AP00 El Manual Del Propietario página 19

7. Wall Control Installation
Skip to Section 7.7 if Using a 3-way Switch
Installation.
SINGLE-POLE INSTALLATION
(One Fan Controlled by One Wall Control)
(See Figures 27 and 28).
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box or circuit breaker panel before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
7.6
Disconnect Electrical Power to the Branch Circuit at
the Circuit Breaker Panel or Main Fuse Box before
attempting to install the Ceiling Fan Wall Control into
the Wall Box .
Before installing Wall Control, place Wall Control in
"OFF" mode by pushing "ON/OFF" Switch (
to the "OFF" ( O ) position .
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
Connect the Wall Control Black Wire labeled
"TO POWER SUPPLY" to the "HOT" 120V AC Supply
Source Wire . Securely connect Wires with Wire
Connector, supplied (Figure 27) .
Connect the Wall Control Black Wire labeled "TO FAN"
to the "LOAD" Black Wire in Wall Box . Securely connect
Wires with Wire Connector, supplied (Figure 27) .
Connect the Wall Control Green Ground Wire to
the Supply Ground Conductor (this may be a Bare
Copper Wire or Wire with Green Colored Insulation) .
Securely connect Wires with Wire Connector, supplied
(Figure 27) .
WARNING
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
(Continued)
SCREWS (2)
SCREWS (2)
DECORATIVE WALL PLATE
Figure 27
HOT BLK
GROUND
)
NEUTRAL
RECEIVER LOCATED IN THE
CEILING COVER OF THE CEILING FAN
Figure 28
Screw Wall Control into Wall Box using the supplied
Screws . Leave Wall Control in "OFF" mode until Fan
installation is completed .
The Wall Control is supplied with a White, Ivory, and
Almond color Switch Covers. Choose the finish that
best suits your needs and snap the Cover onto the Wall
Control (Figure 27) .
Install Decorative Wall Plate using the two Screws
supplied with Wall Plate . Leave the Wall Control in
"OFF" mode until Fan installation is completed
(Figure 27) .
Please contact 1-800-777-4440 for further assistance
19
SW605 FAN/LIGHT
WALL CONTROL
....
OFF
ON
NEUTRAL
SWITCH COVER
WIRES
SW605 FAN/LIGHT
WALL CONTROL
BLACK
GROUND
RECEIVER LOCATED IN THE
SWITCH HOUSING ASSEMBLY
luminancebrands.com
ETL Model No.: CF5200