Luminance Brands Kathy Ireland Home ASHLAND CF717AP02 El Manual Del Propietario página 7

3. Installing Hanger Ball/Downrod Assembly
3.6
Reinstall the Hanger Ball (Figure 6) on the Downrod
as follows . Route the 80-inch Motor Wires through
the Hanger Ball . Position the Pin through the Two
Holes in the Downrod and align the Ball so the Pin
is captured in the Groove in the top of the Hanger
Ball . Pull the Hanger Ball up tight against the Pin and
securely tighten the Set Screw in the Hanger Ball .
A loose Set Screw could create Fan wobble .
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
3.7
The Fan comes with Blue, Black and White Wires that
are 80-inches long . Before installing the Fan, measure
up approximately 6 to 9-inches above top of Hanger
Ball/Downrod Assembly (Figure 7) . Cut off excess
Wires and strip back insulation 1/2-inch from end of
Wires .
(For Standard Mounting) (Continued)
PIN
DOWNROD
Figure 6
1/2-INCH
6 TO 9
INCHES
Figure 7
Please contact 1-800-777-4440 for further assistance
7
HANGER BALL
SET SCREW
BLACK WIRE
BLUE WIRE
WHITE WIRE
HANGER BALL
luminancebrands.com
ETL Model No.: CF717-2