Apprendre à connaître votre compresseur d'air
3
2
Manomètre Réglé
de Sortie d'Air
1
Réservoirs de
stockage d'air
8
Filtre à Aire
11
Jauge d'huile
4
Bouton de
Poignée
Régulateur
5
Manomètre
du Réservoir
6
7
Raccords de
sortie d'air
9
Interrupteur
Marche/Arrêt
10
Robinet de vidange
du réservoir
ridgid.com
1-800-474-3443
Décalque de
modèle/numéro de série
Fr 12
Operating Your Air Compressor
Moisture in Compressed Air
Moisture in compressed air will form into
droplets as it comes from an air com-
pressor pump. When humidity is high or
when a compressor is in continuous use
for an extended period of time, this mois-
ture will collect in the tank. When using a
paint spray or sandblast gun, this water
will be carried from the tank through the
hose, and out of the gun as droplets
mixed with the spray material.
Soupape
de Sûreté
Operating Your Air Compressor
ASME
Make sure the crank case has the, prop-
er oil level. Make sure the tank drain
valve is closed, the regulator knob is
turned fully counterclockwise, and the
On/Off switch is in the OFF position.
Plug compressor into a dedicated 15
Amp (minimum) circuit.
Turn On/Off switch to the ON position.
The compressor will now start building
pressure.
After compressor reaches cut-off pres-
sure, install a hose (with the desired air
For Trouble-Free Operation
1. Read instructions: Carefully read
through this operator's manual
BEFORE OPERATING the new air
compressor. It contains information
about operation and maintenance of
the unit.
2. Drain tank daily: Depressurize system
prior to draining tank. Open tank
drain valve and drain moisture from
tank. This helps keep oil and mois-
ture out of the compressed air sys-
tem. Be sure to close tank drain valve
tightly before operating compressor.
IMPORTANT: This condensation will
cause water spots in a paint job, espe-
cially when spraying other than water
based paints. If sandblasting, it will
cause the sand to cake and clog the gun,
rendering it ineffective.
A filter in the air line, located as near to
the gun as possible, will help eliminate
this moisture.
tool attached) into the outlet fitting.
Adjust the regulator knob to the desired
pressure.
WARNING:
!
Do not over-pressurize any air
tool. Consult air tool instruc-
tions for proper air tool pres-
sure.
The compressor is now ready to operate.
3. Change air filter: Never run compres-
sor without an air filter nor with a dirty
air filter. Replace with a new filter
when it is dirty.
4. Follow maintenance schedule for
checking and changing the oil.
13
Capítulos
