Troubleshooting; Product Maintenance - HAMPTON BAY SKU 888 968 Manual De Instrucciones

TROUBLESHOOTING:

Bulb will not light.
Fuse blows or circuit
breaker trips when light
is turned on.

PRODUCT MAINTENANCE:

1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean
water, never a solvent) to wipe the glass and surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning off the
circuit breaker or by removing the fuse at the fuse box. Next, use a dry or slightly
dampened clean cloth (use clean water, never a solvent) to wipe the inside glass and
interior surface of the fixture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft
cloth to dust or wipe carefully.
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a
period of five (5) years from date of purchase. This warranty applies only to the original consumer purchaser
and only to products used in normal use and service. If this product is found to be defective, the manufacturer's
only obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer's
discretion, provided that the product has not been damaged through misuse, abuse, accident, modifications,
alterations, neglect or mishandling. This warranty shall not apply to any product that is found to have been
improperly installed, set-up, or used in any way not in accordance with the instructions supplied with the
product. This warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse,
negligence, alteration, or faulty installation, or any other failure not relating to faulty material or workmanship.
This warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as
this is considered normal wear and tear. The manufacturer does not warrant and specially disclaims any
warranty, whether express or implied, of fitness for a particular purpose, other than the warranty
contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any
consequential or incidental loss or damage, including but not limited to any labor / expense costs involved
in the replacement or repair of said product.
Possible Cause
1. Bulb is burned out.
2. Power is off.
3. Faulty wire connection.
4. Faulty switch.
Crossed wires or power wire
is grounding out.
LIMITED WARRANTY
Corrective Action
1. Replace light bulb.
2. Make sure power
supply is on.
3. Check wiring.
4. Test or replace switch.
Check wire connections.
Page 8