English - IKEA TRADFRI Manual De Instrucciones

English

FUNCTIONS MOTION SENSOR
Day/Night setting. During the daytime the lights
will always turn on when triggered by motion. At
night the lights will only turn on when it is dark and
they are triggered by motion.
The light sources connected to the motion sensor
can be easily set at either 30% or 100% brightness.
Button for pairing. Add IKEA Smart lighting
products to your system. Follow the instructions
below:
ADDING DEVICES TO YOUR MOTION SENSOR
Before you can use your motion sensor it must be
paired to the light source you want to steer. If you want
to add more light sources, just repeat the steps below
for each individual light source.
1. Make sure that your light source is installed and the
power is turned on.
2. Hold the motion sensor close to the light source you
want to add (no more than 5 cm away).
3. Press and hold the pairing button
seconds. A red LED light will shine steadily on the
rear side of the motion sensor.
4. Your light source will flash one time to indicate that it
has successfully paired.
Up to 10 light sources can be paired with 1 motion
sensor.
Make sure to pair them one at a time. If the light
sources are close to each other, disconnect those that
have already been paired from the main power switch.
4
for at least 10