Luminance Brands Kathy Ireland Home HF1161BQ00 El Manual Del Propietario página 17

7. Wall Control Installation
7.3
Before installing the Supplied Wall Control, place the
Wall Control in the Power "OFF" Mode by pulling the
"ON/OFF" Switch out, located at the bottom of the Wall
Control (Figure 28).
7.4
Securely connect a P2 Wire Connector (supplied with
the wall control) to the Wall Control Black (AC IN L)
Wire and the Wall Box "HOT" Wire (Figure 29).
Securely connect a P2 Wire Connector (supplied with
the wall control) to the Wall Control Black (TO MOTOR
L) Wire and the Wall Box "LOAD" Wire (Figure 29).
Securely connect a P2 Wire Connector (supplied with
the wall control) to the Wall Control Green Ground Wire
and the Wall Box Bare Copper or Green Ground Wire
(Figure 29).
Leave the Wall Control in Power "OFF" Mode until Fan
installation is completed (Figure 29).
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
WARNING
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
(Continued)
ON/OFF SWITCH
(pulled out to the OFF position)
Figure 28
GREEN
WALL CONTROL
ON/OFF SWITCH
(pulled out to OFF position)
Figure 29
Please contact 1-800-777-4440 for further assistance
17
P2 WIRE CONNECTOR
BLACK "LOAD"
WALL BOX
luminancebrands.com
ETL Model No.: HF1161