Application Guidelines; Parts Supplied - Teuco RA10 Instrucciones De Montaje

For the purposes of guarantee validity, the product must be installed as supplied by Teuco.
GB
It is necessary to follow the assembly instructions and only to use the recommended materials and
equipment and the accessories supplied with the product.
This manual is an integral part of the product and therefore, it must be kept in a safe place for future
use, if necessary.
The data and characteristics indicated are in no way binding for Teuco Guzzini Spa, which reserves
the right to make any changes it deems fit without any obligation to give prior warning or supply replacements.
This product has been devised for residential use only. In the event of public use, it is necessary to
guarantee full compliance with specific legislation and standards as well as with the technical and
safety requirements foreseen by Teuco.
The fitter/owner is responsible for checking and adhering to specific local instructions prior to
installation.
All measurements on the figures in this manual are given in millimetres (mm).
APPLICATION
1
GUIDELINES:
The thermostatic mixer tap can only perform at its best
if supplied with hot and cold water with a temperature
difference in excess of 30°C.
differences between the hot and cold water sources
will not affect operation but will affect the speed of temperature regulation.
Hot water must come from pressurised accumulators or
instant water heaters with a power in excess of 20 kW.
The thermostatic mixer tap will not operate if supplied
with hot water at extremely low pressure.
In cases where there is a likelihood of frost, it is advisable
to bleed the water pipes in the home.
If the static line pressure is more than 4 bar, it will be
necessary to use pressure regulators.
2

PARTS SUPPLIED:

The following section describes the parts supplied for use
and operation of the mixer tap:
•
1 mixer tap with protective cap
•
1 wall plate
•
1 selector lever
•
1 temperature regulator
•
1 rubber seal
•
2 M6 screws
14
TIPS AND
There are threaded holes in the body of the mixer tap, which
can be used for attaching metal brackets (not provided)
Lower temperature to secure the device when fitting to prefabricated and/or
plasterboard fitted walls.
The following section describes the installation process for the mixer tap:
•
- Make a cavity in the wall.
- Make sure that there are no particles of dirt or work
- Use the two screws supplied to lock the mixer to the plate
- Position the mixer as illustrated in Figure 3.
- Connect the hot water pipes (left) to the mixer, applying
- Connect the pipe running from the water supply or diverter
•
Before proceeding to wall in the taps, it is necessary to make
sure that there are no water leaks anywhere along the taps
and connections.
Proceed as follows:
- Remove the protective caps "A" and "B" from the mixer,
- Insert the lever supplied on the mixer, as illustrated in
- Use the lever to turn the flow of water on and off in order
- Remove the lever from the mixer.
- Place the protective caps "A" and "B" over the mixer.
- Tighten the check screw of the mixer's protective caps, as
3
INSTALLATION:
POSITIONING THE MIXER
The size of the cavity will vary according to the type and
number of parts in the system.
residues in general inside the hot and cold water pipes.
Bleed the system if required.
on the back of the diverter (optional).
Teflon to the thread on the fitting and then tighten.
(if fitted) to the mixer, applying Teflon to the thread on the
fitting and then tighten.
FITTING THE MIXER
unscrewing the check screw.
Figure 5.
to check for any leaks.
If there are any leaks, shut off the water flow, disassemble
the system and add more Teflon to the threads on the
fittings. Tighten all pipes and fittings and then perform
another flow test.
illustrated in Figure 6.