Teuco RA10 Instrucciones De Montaje página 15

•
WALLING THE DIVERTER AND SYSTEM
- Wall in the cavity, taking care that the base of the
protective cap on the mixer is flush with the wall, as
illustrated in Figure 7.
- Wait for the mortar to harden.
•
TILING THE WALL
- Unscrew the check screw from the mixer protective cap.
- Remove the protective cap from the mixer.
- Divide the protective cap into two sections.
- Fit the rubber seal (supplied) into the mixer and protective
cap "A", as illustrated in Figure 8.
- Fix the protective cap in place with the check screw.
- Tile the wall, taking care to leave a circular area around
the mixer that is approximately 2 cm wider than the
diameter of the protective cap.
•
FITTING THE WALL PLATE
- Unscrew the check screw of the mixer protective cap "A".
- Remove the protective cap "A" from the mixer.
- Place the shim over the mixer, as illustrated in Figure 10.
- Fit the wall plate supplied over the mixer, so that it is flush
with the tiles.
•
FITTING AND SECURING THE LEVER
- Place the selector lever on the mixer.
- Tighten the selector lever with the grub screw supplied, as
illustrated in Figure 11.
•
FITTING AND SECURING THE TEMPERATURE
REGULATOR
- Insert the temperature regulator over the mixer, as illustrated
in Figure 12.
- Turn the lever so as to open the water outlet.
- Turn the temperature regulator until the water comes out at
38°C (check this temperature with a thermometer, which is
not supplied).
- Remove the temperature regulator from over the mixer.
- Insert the temperature regulator over the mixer so that the
38°C indication is in line with the mark on the lever.
- Tighten the temperature regulator with the grub screw
supplied.
•
FINISHING THE SYSTEM
- Place the cap over the housing of the grub screw securing
the temperature regulator, as illustrated in Figure 13.
15