Debug Table - Pfannenberg CCE Standart Serie Instrucciones De Operación Y Instalación

At this time the Chiller is ready to operate automatically according to the controllers "set point values". If necessary, set
controller according to customers temperature requirements. (Please refer to the manual of the thermostat delivered with the
unit).
NOTE: The unit works correctly only if the cover panels are mounted on the unit, so if for some
reason during the installation of the Chiller they have been removed, please replace them
before switching on the unit.
After installation, the REFRIGERATOR does not need intervention by the Qualified Operator.
Every calibration operation on thermostats, pressure switch and whatever component of the refrigerating circuit, the personnel
of the Service Pfannenberg only is competent.
For further information on chiller installation, start-up or troubleshooting please contact PFANNENBERG Sales Support.

Debug Table

The information described below are useful for the service staff. The faults that require the intervention of a refrigeration
engineer must be carried out only by specialized staff. Follow all electrical legislation when working on the unit based on valid
laws of the countries were the unit is placed.
Problem
The unit does not start No supply voltage
up
Not working thermostat
70040-120_01-_-(CCE_Op._Manual_EN-DE-IT-ES-FR-RU).docx
English
Picture 16 – Fan
Chiller
Cause
Check the supply main voltage line
Inspect the connection, verify the auxiliary circuit fuses and, if there is no fault,
replace the thermostat.
Possible corrective Action
15