Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Anleitung_TC_MX_1400_E_SPK8__ 09.12.14 08:34 Seite 15
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
Mixer assembly (Fig. 2):
First scew mixer part (4a) together with mixer part
(4b). Screw the mixer (4) into the mixer holder (3)
afterwards. Use the two spanners to do this. Use one
of the spanners (a) to hold the mixer holder (3) in
place and then use the second spanner (b) to tighten
up the mixer (4). Proceed in the reverse sequence to
undo the mixer.
is secure (pull the mains plug).
6. Operation
6.1 ON/OFF switch (Fig. 3/Item 1)
First fit a suitable mixing tool to the equipment
n
(see 5.)
Connect the mains plug to a suitable socket.
n
To switch on:
Press the ON/OFF switch (1)
Continuous operation:
Secure the ON/OFF switch (1) with the locking
button (2).
To switch off:
Press the ON/OFF switch (1) briefly.
6.2 Adjusting the speed (Fig. 3/Item 1)
You can infinitely vary the speed whilst using the
n
tool.
Select the speed by applying a greater or lesser
n
pressure to the ON/OFF switch (1).
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning and maintenance
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
n
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
9. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
10. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
GB
15
Capítulos
Tabla de contenido
