Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Care and Cleaning
Figure1
(Locktab is visibleonly afterdrawer has
been pulledout)
Figure 2
Figure 3
Outside
•
When washing is completed, wipe top and sides of washer with a damp
cloth. Turn water faucets off to prevent pressure build-up in the hoses.
As needed, clean the cabinet with mild soap and water. Never use harsh,
gritty or abrasive cleansers. If door or console becomes stained, clean
with diluted chlorine bleach [1/2 cup (120 ml) in 1 quart (.95 L) water].
Rinse several times with clear water.
Remove glue residue from tape or labels with a mixture of warm water and
mild detergent. Or, touch residue with the sticky side of the tape or label.
Before moving the washer, place a strip of cardboard or thin fiberboard
under the front leveling legs to prevent floor damage.
Cleaning
the Dispenser
Drawer
Area
Detergent and fabric softener may build up in the dispenser drawer. Residue
should be removed once or twice a month.
Remove the drawer by first sliding the safety latch to the dght, then pulling
the drawer out until it stops. (Figure 1)
Reach back intothe left rear corner of the drawer cavity and press down
firmly on the lock tab (left rear portion of the drawer). Pull out the drawer.
(Figure2)
Remove the inserts from the bleach and fabric softener compartments.
(Figure3)
Rinse the drawer and inserts with hot tap water to remove traces of
accumulated powders and liquids. Large amounts of fabric softener
residue may indicate improper dilutionor more frequent cleaning is
required.
To clean the drawer opening, use a small brush to clean the recess.
Remove all residue from the upper and lower parts of the recess. (Figure 4)
Return the bleach and fabric softener inserts to their proper compartments.
Replace the dispenser drawer and run the Prewash cycle without any wash
load in the drum.
Inside
•
Removeitemsfromthe washeras soonas the cycleends. Excess
wdnlding, c olortransfer,and odorsmay developinitemsleft inthe washer.
•
Before cleaning the washer interior, unplug the electrical power cord to
avoid electrical shock hazards.
Dry around the washer door opening, flexible gasket, and door glass.
These areas should always be clean to ensure a water tight seal.
When extremely soiled items have been washed, a dirty residue may
remain on the drum. Remove this by wiping the drum with a nonabrasive
household cleanser. Rinse thoroughly with water.
The plastic drum vanes may become stained from fabric dye. Clean these
parts with a nonabrasive household cleanser. This prevents dye transfer to
future loads.
10
Capítulos
Tabla de contenido
