Connecting The Water Supply; Connecting The Drain Hose - Brandt WFH 1270 K Manual De Instrucciones

1. Loosen the locking nuts on the feet
with the open ended spanner.
2. Adjust feet until the appliance is level
and does not rock.
3. Important: Tighten all locking nuts af-
ter the machine has been levelled.

Connecting the water supply

This appliance can be connected to water
tabs with a 3/4" B.S.P. thread.
Important:
• Observe the permissible water pres-
sure and the max. inlet temperature
(see "Technical Specifications"). Install
a pressure reducing valve if the water
pressure is higher.
• Do not connect to a water heater (in-
stantaneous water heater or unpressu-
rised boiler), as the water pressure is
insufficient.
• Check with customer service for hose
extensions. Do not use homemade ex-
tensions with hose clamps or similar!
• Use only the new hose supplied with
the machine, not an old existing one!
• Ensure that there are no sharp bends
in the hose!
Required tools: None. (Do not use a pipe
wrench!)
1. If not already mounted, the offset side
of the inlet hose is to be screwed "fin-
ger-tight" to the water inlet port at the
rear of the appliance.
2. Connect the other end of the inlet
hose "finger-tight" to the water tap.
3 The "Aquastop" resp. "Aquastop PLUS"
(according to model) turns off the wa-
ter inlet, if a leakage occurs.
3. Open the water tap fully and check all
connections for tightness; close water
tap again. Correct the position of seals
and screw couplings, if necessary.

Connecting the drain hose

The drain hose can be hung to a wash-ba-
sin, sink or bathtub – or connected perma-
nently to a siphon trap.
Important:
• Do not run the drain hose higher than
100 cm above floor level for the suds
pump to be able to pump out.
• The water must be able to run off un-
hindered. Washbasins with a small
drain are not suitable.
• The end of the hose must not im-
merge in the pumped-out water.
• Check with customer service for hose
extensions. Do not use homemade ex-
tensions with hose clamps or similar!
• Use only the new hose supplied with
the machine, not an old existing one!
• Ensure that there are no sharp bends
in the hose!
Fastening the hose holder:
1. Pull the hose holder supplied over the
end of the drain hose.
Aquastop /
Aquastop PLUS
45
G