RedMax BCZ350S Manual De Instrucciones página 16

BCZ350S
4. Set up
The guard extension is removed easily using the spark plug
spanner, see illustration.
■ Fitting a blade guard, grass blade and grass cutter
A
• Hook the blade guard/combination guard (A) onto the fitting on
the shaft and secure with the bolt.
CAUTION! Ensure that the guard extension is removed.
Use the recommended blade guard. See the Technical data
section.
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Place the blade (D), support cup (E) and support flange (F) on
the output shaft.
• Fit the nut (G). The nut must be tightened to a torque of 35-50
Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the
shaft of the spanner as close to the blade guard as possible. To
tighten the nut, turn the spanner in the opposite direction to the
direction of rotation (Caution! left-hand thread).
US-14
G
F
E
D
B
A
C
■ Fitting other guards and cutting attachments
• Fit the trimmer guard/combination guard (A) intended for use
with the trimmer head/plastic blades.
CAUTION! Ensure that the guard extension is fitted.
Hang the trimmer guard/combination guard (A) on the two
hooks on the plate holder (M). Bend the guard around the shaft
and tighten it with the bolt (L) on the opposite side of the shaft.
Use the locking pin (C).
Place the locking pin in the groove on the screw head and
tighten. See diagram.
M
A
• Fit the drive disc (B) on the output shaft.
H
B
M L
L
C
A